What happens during an MOT tyre check? +
During an MOT, the examiner checks that all tyres are the correct size and speed rating for the vehicle, that tread depth is at least 1.6mm across the central three-quarters, that there are no cuts, bulges, or exposed cords, and that tyres on the same axle are of the same type (e.g. not mixing radial and cross-ply). Incorrect tyre pressure is not an MOT failure but the examiner may issue an advisory.
What are run-flat tyres and can any fitter work on them? +
Run-flat tyres have reinforced sidewalls that support the weight of the car even with no air pressure, allowing you to drive up to 50 miles at 30mph after a puncture. They require specialist fitting equipment and a TPMS reset after replacement. Not all garages can work on run-flat tyres, but most professional mobile fitters and tyre centres are fully equipped. Run-flat tyres are typically 20–40% more expensive than standard equivalents.
How long does it take to fit a new tyre? +
A single tyre change typically takes 15 to 30 minutes, including removing the old tyre, fitting and balancing the new one, and torquing the wheel nuts to the correct specification. If you are having all four tyres replaced, expect the job to take around 45 minutes to an hour. Mobile fitters work to the same timescales as a garage.
What does the TPMS warning light mean? +
The TPMS (Tyre Pressure Monitoring System) warning light indicates that one or more of your tyres has dropped below the recommended pressure. This could be caused by a slow puncture, a change in temperature, or simply natural air loss over time. Do not ignore it — under-inflated tyres increase braking distances and can overheat at speed. Check your pressures at the nearest petrol station or call a mobile tyre fitter.
What is the difference between budget and premium tyres? +
Premium tyres from manufacturers like Michelin, Continental, and Bridgestone consistently outperform budget alternatives in independent braking tests — often stopping several metres shorter in wet conditions. They also tend to last longer, produce less road noise, and offer better fuel economy. For a typical family car, the difference between a budget and premium tyre is usually £25–£40 per tyre, which most drivers recoup through longer tread life.
What is the legal minimum tyre tread depth in the UK? +
The legal minimum tread depth in the UK is 1.6mm across the central three-quarters of the tyre, around its entire circumference. However, most motoring organisations recommend replacing tyres at 3mm, as braking performance drops significantly below this level. Driving on tyres below 1.6mm carries a fine of up to £2,500 and 3 penalty points per illegal tyre — so four bald tyres could mean a £10,000 fine and 12 points.