What happens during an MOT tyre check? +
During an MOT, the examiner checks that all tyres are the correct size and speed rating for the vehicle, that tread depth is at least 1.6mm across the central three-quarters, that there are no cuts, bulges, or exposed cords, and that tyres on the same axle are of the same type (e.g. not mixing radial and cross-ply). Incorrect tyre pressure is not an MOT failure but the examiner may issue an advisory.
What is the difference between budget and premium tyres? +
Premium tyres from manufacturers like Michelin, Continental, and Bridgestone consistently outperform budget alternatives in independent braking tests — often stopping several metres shorter in wet conditions. They also tend to last longer, produce less road noise, and offer better fuel economy. For a typical family car, the difference between a budget and premium tyre is usually £25–£40 per tyre, which most drivers recoup through longer tread life.
Should I check my tyre pressures regularly? +
Yes — you should check tyre pressures at least once a month and before any long journey. Under-inflated tyres increase fuel consumption by up to 3%, reduce braking performance, and cause uneven wear that shortens tyre life. Over-inflation reduces grip and causes the centre of the tread to wear faster. Your correct pressures are listed in the vehicle handbook and on a sticker inside the driver's door frame or fuel filler cap.
What should I do if I get a flat tyre on the motorway? +
Pull onto the hard shoulder as far left as possible, switch on your hazard lights, and exit the vehicle from the passenger side away from traffic. Do not attempt to change a tyre on the motorway hard shoulder — it is extremely dangerous. Move behind the crash barrier if there is one, then call a mobile tyre fitter or breakdown service. If you are on a smart motorway with no hard shoulder, stop in an emergency refuge area.
What is the legal minimum tyre tread depth in the UK? +
The legal minimum tread depth in the UK is 1.6mm across the central three-quarters of the tyre, around its entire circumference. However, most motoring organisations recommend replacing tyres at 3mm, as braking performance drops significantly below this level. Driving on tyres below 1.6mm carries a fine of up to £2,500 and 3 penalty points per illegal tyre — so four bald tyres could mean a £10,000 fine and 12 points.
How do I read my tyre size? +
Your tyre size is printed on the sidewall in a format like 205/55R16 91V. The first number (205) is the width in millimetres, the second (55) is the aspect ratio as a percentage of the width, R means radial construction, and 16 is the wheel diameter in inches. The number after (91) is the load index and the letter (V) is the speed rating. Your vehicle handbook and the sticker inside the driver's door frame show the correct size for your car.